Whirlpool Oven / Range Error Codes

Troubleshooting & Repair Guide

Control System Errors
F0
Electronic Control Failure
  • Disconnect power for 5–10 minutes.
  • Inspect control board for damage or burn marks.
  • Check wiring harness connections.
  • Replace control board if issue persists.
F1
Touchpad / Control Board Error
  • Clean touch panel surface.
  • Check ribbon cable connection.
  • Inspect for moisture or damage.
  • Replace UI panel if needed.
Keypad / Interface Errors
F2 / E0
Keypad Disconnected
  • Check keypad ribbon cable.
  • Inspect connector pins for corrosion.
  • Reseat connection properly.
  • Replace keypad module if needed.
Temperature System Errors
F3 / E0
Oven Temperature Sensor Fault
  • Test oven temperature sensor (NTC).
  • Inspect wiring for breaks.
  • Check resistance values.
  • Replace sensor if faulty.
F3 / E2
Overheating in Bake Mode
  • Check heating element relay.
  • Inspect temperature sensor calibration.
  • Ensure proper airflow inside oven.
  • Replace thermostat or board if needed.
F3 / E3
Overheating in Self-Clean Mode
  • Check thermal fuse condition.
  • Inspect cooling fan operation.
  • Reset oven after cooling down.
  • Service required if repeated.
Probe System Errors
F4 / E1
Meat Probe Malfunction
  • Check probe connection jack.
  • Inspect probe cable for damage.
  • Test continuity of probe sensor.
  • Replace probe if faulty.
Door / Safety Lock Errors
F5 / E0
Door Latch Switch Error
  • Inspect door latch alignment.
  • Check door switch wiring.
  • Ensure door closes fully.
  • Replace switch if necessary.
F5 / E1
Self-Clean Latch Problem
  • Allow oven to cool completely.
  • Check latch motor operation.
  • Inspect mechanical lock assembly.
  • Replace latch motor if stuck.
Important: If error persists after troubleshooting, disconnect power immediately and contact a certified appliance technician.